Fall phones

Problem: Accidentally our phone is dropped, because the phone fell off the phone, after that we try to turn it back on our cell phone but the phone did not want to flame the total return presumed dead. 
Repair procedure : 

* We can not directly examine and test the phone with the power supply, it is intended to prevent short circuit between components or modules in mobile phones. Because most likely after the phone fell off the location rather than component or module in the mobile phone changed and is not in place, this is feared could cause a short circuit between components or modules in mobile phones. 

* So the first cell phone must be disassembled, heated (diblower), then we reposition or re-location of the position of each component or module that has changed its place as a result of the phone that had fallen earlier. 

* After we unpacked, heating, and repositioning of all the layout components or modules in place so then we may use the power supply to inspect and test our cell phones if the damage is located in the software or hardware. 

* Most likely a damaged components as a result of mobile phone which had fallen earlier is PA or IC Power IC. 

* However, if the needle scale amperes at power supply increased by about ± 50 milli ampere when the 'on' on the phone is pressed, it means the damage is located in the software phone. We do the program (flash) on the phone according to the type and version of your current cell phone or we can do process of upgrading the software version to the version of software that is higher than the previous version of your phone. 

* Try to turn your phone back, your phone must have a flame.

Simak

Baca secara fonetik