Repair Techniques Nokia Series E61

There will be no end if we deal with mobile phone repair techniques, you can imagine in a month if there are five even ten type phone that is issued, all of which are distinct lines and shapes, it will be different ways to handle it. This means there will be many kinds of repair techniques for various types of mobile phones and this edition we will try mebahas damage in type series natural for nokia E61, mobile phone output this year which has the same form with the PDA. Apparently there is some damage that we can fix themselves. Here are some problems that can happen on your Nokia E61.

Damage Path Switch On Off
At this damage can not turn the phone normally, by pressing a switch on off but if in connected with this mobile phone charger will bring up the image charge on the layer, which means the program as well as other components are still functioning properly Or you can use the flasher tool, restart the phone in the normal state, restart in normal mode. If checking the above work well but the phone still can not turn on normally, then we need to check off switch on its path.

Damage Joystick
In addition to the keypad buttons phone also comes with a joystick for menu settings and other functions, if any damage on the joystick to select the menu that dynamic becomes difficult, such as the selection menu in the middle or running applications.Joystick is regulated by components or IC, located close to the MMC slot, or called the driver, if the driver lifted his foot or something not connected then the joystick function becomes impaired, to fix the first try in rehot or in the heat with hot water or in the solder re- at the foot of his leg. 

Damage to the LCD IC
For setting the LCD this phone has two components as a liaison between the LCD and CPU, the path components that serve to convey signals from the CPU to the display on the LCD layer, if it is corrupt, the LCD can not menamplkan image or usually if both components of the legs legs LCD apart striped or blurred images, and even display only a white screen.
The first step if the phone is a symptom of damage to the LCD make it a habit to check the cables connected to the connector, and check the feet of his legs because of the wear foot copper connector attached to the PCB, if tenuous attempt at his feet resolder.
The second repair program, because the program also berpebgaruh to display images on the LCD, you can use the tool's first flasher unlock, if not managed well in re-format (in Flash)
If second step is not successful then you can try to heat the two components (in the figure below) are attached to the foot of his leg again, or try to removed and installed again. However, if the component is damaged it must be replaced, but if a replacement component is missing then you can perform a simple way to connect the path component as shown below. Do it with caution not to get the wrong path, because it causes the LCD is not alive.